EXOS save configuration and show config
- Fundamentals
- Beginner
- 5 min
- 3 steps
- EXOS-style
EXOS persistence: save configuration writes running to nvram so it survives a reload. show configuration dumps the same content in flat command form.
Open this lab in your browser →
Free · no install · no account
Scenario
EXOS doesn't have a candidate-config layer — every command applies immediately. So persistence is one step, not two: save configuration. If you forget it, the change is gone on reboot.
Topology
1 × switch · EXOS-style
sw1— switch
What you will do
Create VLAN
corp(tag 100) so we have something to persist.Persist running to nvram with
save configuration.show configurationto see the running config in flat command form.
Open this lab in your browser →
More labs on this topic
- Break and fix — your first troubleshooting walkBeginner · 10 min
- Config mode — your first configuration changesBeginner · 10 min
- EXOS break and fix — port disabledBeginner · 8 min
- EXOS config — create a VLAN, add a port, give it an IPBeginner · 10 min
- Your first ExtremeXOS switch — VLAN-centric readsBeginner · 8 min
- EXOS ping and tracerouteBeginner · 5 min
This lab in other languages
EXOS save configuration und show configEXOS save configuration y show configEXOS save configuration e show configEXOS save configuration et show configEXOS save configuration और show configEXOS save configuration 与 show configEXOS save configuration e show configEXOS の save configuration と show configEXOS save configuration과 show configEXOS save configuration и show configEXOS save configuration ve show configEXOS save configuration và show config