Network labs Docs Open simulator →

Your first ExtremeXOS switch — VLAN-centric reads

A single ExtremeXOS switch. Three op-mode shows that introduce the EXOS mental model — VLANs are top-level objects (not interface attributes), ports are referenced by number (not by name).

Open this lab in your browser →

Free · no install · no account

Scenario

ExtremeXOS is structurally different from Cisco. Two big shifts: 1. VLAN-centric, not interface-centric. A VLAN is a top-level object with its own name. Ports are *added to* VLANs. The VLAN owns the L3 IP if it's an SVI. There's no interface Ethernet1/0/1 mode. 2. Flat command grammar. No configure terminal REPL. Each line is a complete operation: create vlan, configure vlan <name> add ports <list>, enable ipforwarding. A bit closer to a shell than to a Cisco-style nested config. The switch sw1 is pre-loaded with three Ethernet ports (Ethernet1, Ethernet2, Ethernet3) and the always-present default VLAN Default (id 1).

Topology

1 × switch · EXOS-style

What you will do

  1. Type show version to see the EXOS identity banner.

  2. Run show ports. Lists each physical port with its admin / link state.

  3. Run show vlan to see the VLAN database. The default VLAN Default (id 1) is always present.

Open this lab in your browser →

More labs on this topic

This lab in other languages

Dein erster ExtremeXOS-Switch — VLAN-zentrierte ReadsTu primer switch ExtremeXOS — lecturas VLAN-céntricasSeu primeiro switch ExtremeXOS — leituras VLAN-cêntricasTon premier switch ExtremeXOS — lectures VLAN-centréesआपका पहला ExtremeXOS switch — VLAN-केंद्रित reads你的第一台 ExtremeXOS 交换机 — 以 VLAN 为中心的查看Il tuo primo switch ExtremeXOS — read VLAN-centriciはじめての ExtremeXOS スイッチ — VLAN 中心の read첫 ExtremeXOS switch — VLAN 중심의 readТвой первый ExtremeXOS-свитч — VLAN-центричные read'ыİlk ExtremeXOS switch'in — VLAN merkezli read'lerSwitch ExtremeXOS đầu tiên của bạn — read theo hướng VLAN