EXOS ping and traceroute
- Fundamentals
- Beginner
- 5 min
- 3 steps
- EXOS-style
Two EXOS switches, each with an SVI on a shared VLAN. Send packets with ping <ip> and traceroute <ip>.
Open this lab in your browser →
Free · no install · no account
Scenario
EXOS connectivity tools are flat-grammar like the rest: ping <ip> and traceroute <ip>, both run from the operator shell. No mode entry. Both switches are pre-loaded with the corp VLAN (tag 100), an SVI, and ipforwarding enabled.
Topology
2 × switch · EXOS-style
sw1— switchsw2— switch
What you will do
On
sw1, build VLANcorp(tag 100), add port 1 untagged, give the VLAN10.0.0.1/24, enable forwarding.Repeat on
sw2: same VLAN, same port 1, address10.0.0.2/24.From
sw1, pingsw2at10.0.0.2.
Open this lab in your browser →
More labs on this topic
- Break and fix — your first troubleshooting walkBeginner · 10 min
- Config mode — your first configuration changesBeginner · 10 min
- EXOS break and fix — port disabledBeginner · 8 min
- EXOS config — create a VLAN, add a port, give it an IPBeginner · 10 min
- Your first ExtremeXOS switch — VLAN-centric readsBeginner · 8 min
- EXOS save configuration and show configBeginner · 5 min
This lab in other languages
EXOS ping und tracerouteEXOS ping y tracerouteEXOS ping e tracerouteEXOS ping et tracerouteEXOS ping और tracerouteEXOS ping 与 tracerouteEXOS ping e tracerouteEXOS の ping と tracerouteEXOS ping과 tracerouteEXOS ping и tracerouteEXOS ping ve tracerouteping và traceroute trên EXOS